Paint Protection Film (PPF) is an amazing discovery that ensures the protection of your car’s paint and keeps it in great condition for years. It acts as a shield against air pollution, bird droppings, tree sap, stone chips, scratches, and more. Though the coating comes in various qualities, the car undergoes the same processing before the final application of the PPF in every case. Before the final application of the car ppf in Kolkata, some things need to be kept in mind for the installation to go on perfectly.
Steps before PPF Installation
There are certain steps to follow before the installation of the PPF. Brush up your knowledge before you get started.
- Vehicle Inspection: The PPF is a clear layer that will act as a shield from future damage. However, if any scratch is already present, then it will be clearly visible. Installers will check for all imperfections. If a little paint correction is needed, then it will have to be done beforehand.
- Cleaning the Car: This is a crucial step. The vehicle needs to be free of all debris, dirt, and grime. Every edge and corner has to be free of dirt because once the layer is applied, any imperfection will lead to bubbles and peeling. Make sure the surface is wiped with distilled water and isopropyl alcohol to get rid of any traces of oil or wax. The car must be completely dry and clean before the work begins.
- Slip Solution: The installation process begins with the use of the slip solution. This is usually a mix of distilled water and some baby shampoo. The concoction, when sprayed generously, helps the film slip over the paint easily. The idea is to lay it properly over the paint without it sticking early. This prevents any bubbles from getting trapped under it. A professional will use a squeegee to press out air and stick it to the paint.
- Cutting the Portions: Precision is important when it comes to using bulk film. If you are using pre-cuts, then the job becomes easier. Ensure that the pieces are slightly oversized so that you get enough space to stick them properly. Alignment is key to sticking the pieces properly. Once they are in place, use the squeegee from the centre outward to get rid of the air and slip solution.
- Installation and wrap-up: The installation part is critical and should not be attempted by amateurs. Let the professionals handle this part because using the squeegee requires a certain kind of expertise. The final sticking and heat application is a complex procedure that, when done properly, prevents reapplications. A follow-up is also needed to ensure that bubbles have been avoided totally and all the edges have been wrapped up properly.
Conclusion:
Post-installation, water should not be applied to the car for at least 48 hours. There is a list of do’s and don’ts that needs to be followed to avoid any damage to the freshly applied PPF coating. For a professional-level PPF application, contact Prime Car Care.